ALKEN® 862 DEMULSIFIER
Effective Date: 08/04/2006
Manufacturer's Name: Alken-Murray Corporation | |
Manufacturer's Address: P.O. Box 400, New Hyde Park, New York 11040 | |
T: 540-636-1236 Fax: 540-636-1770 | |
E-mail: msds@alken-murray.com | |
Manufacturer's Cage Code: 2A384 | |
For chemical emergency - spill, leak, fire or accident - call CHEMTREC - day or night - (800) 424-9300 or outside the USA (703) 527-3887 |
NFPA Hazard Ratings: |
Synonyms: | Alken Even-Flo 910 |
CAS Number: | Not applicable to mixtures |
Chemical Formula: | mixture |
Formula ID Codes: | 862/910 |
Chemical Name | CAS Number | OSHA PEL | ACGIH TLV | % Weight |
Aliphatic petroleum solvent (Naphtha) | ||||
Non-ionic surfactant | ||||
Aliphatic & cyclic amines |
Emergency Overview: Caution: Eye and respiratory irritant. Potential Health Effects: |
|
|
Flash Point: 150 degrees F O(65.5 degrees C) Flammability Limits: NA Autoignition temp: NA Fire Extinguishing Media: Foam, water fog, carbon dioxide, dry chemical. Do not use a direct stream of water. Product will float and can be reignited on surface of water. Special Fire-Fighting Information: When entering confined space, wear positive pressure NIOSH-approved SCNA, full bunker gear (helmet with face shield, bunker coats, gloves and rubber boots) Use water spray to cool containers, to prevent weakening of container structure or buildup of vapor pressure which could result in container rupture. Unusual Fire and Explosion Hazards: Vapors are heavier than air and may travel along the ground. |
Caution - combustible. Eliminate potential sources of ignition. Wear Appropriate respirator and other protective clothing. Contain spill. Remove with vacuum trucks or pump to storage/slavage vessels. Soak up residue with an absorbent such as clay, sand, or other suitable material; place in non-leaking containers and seal tightly for proper disposal. Flush area with water to remove trace residue dispose of flush solution as above. For Small Spills: Take up with an absorbent material and place in a non-leaking container for proper disposal. |
Store in cool dry place. Keep container closed when not in use. |
|
|
|
|
|
RCRA Hazard Class (if discarded): This product is not considered a hazardous waste according to RCRA regulations. Wash containers down with water before disposal. Dispose in accordance with federal, state and local regulations for heating fuel. |
|
..................................Section 302/304 Extremely Hazardous Substances: None ..................................Section 311 Hazard Categorization: Acute health, chronic, delayed health, Fire ..................................Section 313 Toxic Chemicals: None
|
16. Other Information Reason for Revision: Routine review & revision Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages. |